User manual

RIGOL Chapter 2 Front Panel Operations
2-12 DP700 User’s Guide
completed outputting operation for a specified number of times (total number of
output groups).
(1) Press the Up/Down arrow key to switch the parameter focus to "Trig Mode".
(2) Press the Left/Right arrow key or use the knob to select the desired trigger
mode.
5. Select the end state
"End State" refers to the state of the instrument after it has completed
outputting groups of voltage and current values for a specified number of times
(the total number of output groups) when the number of cycles is a finite value.
Outp Off: indicates that the output will be turned off automatically after the
output is completed.
Last: keeps the output state (voltage/current) of the last group after the output
is completed.
(1) Press the Up/Down arrow key to switch the parameter focus to "End State".
(2) Press the Left/Right arrow key or use the knob to select the desired end
state.
6. Edit the timing parameter list
The timing parameters are used to control the output of the instrument. The
parameters consist of the group ID, the output voltage, the output current, and
duration time. You can select a group ID first and then set the timing
parameters for the group.
(1) Select a group ID
If the parameter focus is currently on the "Group ID" line, press the
Left/Right arrow key or use the knob to select the desired group ID directly,
or use the num key to select the desired group ID. For setting methods,
refer to the descriptions of the help information displayed at the bottom of
the interface or refer to the descriptions in "Parameter Setting Method".
If the parameter focus is currently not on the "Group ID" line, first press the
Up/Down arrow key to switch the parameter focus to the "Group ID" line,
and then select the desired group ID.
(2) Set the output voltage
Tip
When "Cycles" is set to "Infinite", "End State" is invalid.
Group ID
Output Voltage
Output Current
Duration Time
One Group of Timing Parameters