User manual

Chapter 2 Front Panel Operations RIGOL
DP700 User’s Guide 2-5
Constant Current Output
In the constant current (CC) mode, the output current equals to the current setting
value, and the output voltage is determined by the load. This section introduces the
operation method for CC output.
Operation Methods:
1. Connect the load with the channel output terminals
Turn off the instrument. Connect the load with the channel output terminals on
the front panel.
CAUTION
While making a connection, the positive
polarity of the load should be connected to
the (+) terminal of the channel output, and
the negative polarity of the load to the (-)
terminal of the channel output. A
misconnection with the terminals may cause
damage to the instrument and the devices
connected to it.
2. Turn on the instrument
Press to turn on the instrument.
3. Set parameters for the channel output
Set the output voltage
(1) In the main interface, press the
Up/Down arrow key to switch the
parameter focus to "Voltage Setting
Value".
(2) Use the num key or the knob to set a
desired value for the output voltage.
For setting methods, refer to the
descriptions of the help information
displayed at the bottom of the
corresponding interface or refer to the descriptions in "Parameter Setting
Method".
Set the output current
(1) In the main interface, press the Up/Down arrow key to switch the
parameter focus to "Current Setting Value".
(2) Use the num key or the knob to set a desired value for the output current.
For setting methods, refer to the descriptions of the help information
OVP Setting
OCP Setting
Voltage Setting Value
Current Setting Value