User manual

RIGOL Chapter 1 Quick Start
1-10 DP700 User’s Guide
Rear Panel
AC SELECTOR
100Vac 120Vac 220Vac 240Vac
100V T5A
120V 250Vac
220V T2.5A
240V 250Vac
FUSE RATING
RIGOL TECHNOLOGIES,INC.
MADEINCHINA
Figure 1-4 Rear Panel
1. Input Power Requirement
The requirement for the power and frequency of the AC input power.
2. AC Power Supply Connector
Plug the specified power cord available in the accessories into the AC power
supply connector of the instrument, and then connect the instrument to the AC
power.
3. RS232 Interface
You can remotely control the DP700 series power supply via the interface.
Pin 7 and Pin 8 of the RS232 interface are not used in remote communication.
They are used in the trigger function. Trigger is an optional function. If you want
to use the trigger function, order the trigger option based on the Order No.
available in "Appendix A: Order Information", and then install the option by
referring to "Option Configuration".
4. Air Outlet
Decrease the temperature inside the instrument to ensure its performance.
When you place the instrument on the workbench or install it into the rack, keep
the air outlet from a distance of 10 cm to ensure adequate ventilation.
5. Fuse Cap
When leaving the factory, the instrument has installed a fuse that conforms to
7. AC Selector
6. Fuse Rating
5. Fuse Cap
4. Air Outlet
1. Input Power
Requirement
2. AC Power
Supply Connector
3. RS232 Interface