User manual

RIGOL Chapter 1 Quick Start
1-8 DP700 User’s Guide
6.2 Confirmation key
OK
(1) Confirm the currently selected item.
(2) Enable/disable the specified function, such as overvoltage
protection (OVP) and overcurrent protection (OCP).
(3) Select the default voltage unit (V) and the default current
unit (A).
(4) Control the timing output.
When the trigger mode of the timer is set to "Single", one
single press on OK enables a single output based on one
group of timing parameters, until the instrument has
completed outputting operation for a specified number of
times (total number of output groups).
7. Knob
Note: Rotating the knob in different interfaces can
produce different operation results. Here introduces its
common usage. As for its other functions and usages,
refer to the detailed introduction described in later
sections of the manual. You can also refer to the help
information at the bottom of the instrument interface.
(1) Switch the parameter focus.
(2) Modify the value where the cursor stays.
(3) Switch the parameters or parameter values.
(4) Enter a negative measurement value.
During the manual calibration process, you can use
the knob to enter a negative measurement value.
(5) Switch the tab.
Press System to enter the system utility function
interface, and rotate the knob to select different tabs.