User manual

Chapter 1 Quick Start RIGOL
DP700 User’s Guide 1-5
current DAC calibration, voltage ADC calibration,
current ADC calibration, and OVP calibration.
(5) Option configuration
 View the installation status of the options, such as
Trigger, Timer, and High Resolution.
 Install the options. For the installation methods, refer
to "Option Configuration".
2.2 Storing and recalling operation key
Memory
(1) Restore the instrument settings to defaults.
For default settings, refer to Table 2-3.
(2) Clear all saved files.
Clear all saved state files and timer files.
(3) Store, recall, or delete files.
The DP700 series can store up to 10 state files and 2 timer
files.
2.3 Timer key
(1) Set parameters for timer: the number of output groups, the
number of cycles, trigger mode, end state, output voltage,
output current, and duration time.
Note: When you press Timer to enter the timer interface,
the channel output is automatically disabled.
(2) Close the timer and return to the main interface.
During the timing output, press Timer and select "YES" to
close the timer and return to the main interface.
3. Output On/Off Key
(1) Enable or disable the channel output.
In the main interface or other function interfaces (including
the system utility function interface, store and recall
interface; excluding the timer interface), the On/Off key is
used to enable/disable the channel output.
(2) Enable or disable the timing output.
 In the timer interface, after setting the parameters for
the timer, press On/Off to enable the timing output.
 During the timing output, press On/Off to disable the