User Guide

RIGOL Chapter 2 Front Panel Operations
User’s Guide for DP1308A
2-12
Timing Output
Press Timer to enable the timing output of current channel, at this moment, the
button light goes on and a “Clock” icon and the corresponding timing parameters are
shown on the screen. See the figure below. The instrument will start output after you
turn on the current channel until finishing all timing outputs. (at the same time, the
light of Timer button goes out.)
If no timing parameters have been set before enabling the timer, the system will enter
“Timer Setting” Interface automatically after you press Timer (the light goes on).
In timing mode, if you turn off the channel under timing, the timer will stop until it is
enabled again. However, the timer would be disabled once you press Timer during
timing.
Figure 2-12 Timing output (in focus display mode)
In focus display mode, the character “Set” on the screen denotes the current output
voltage and current setting value while “Next” denotes the next output voltage and
current setting value. The next output value does not displayed in normal display
mode, see the figure below.
Figure 2-13 Timing output (normal display mode)
Clock icon
Specified
time