User Guide

Chapter 2 Front Panel Operations RIGOL
User’s Guide for DP1308A
2-11
8. O.C.P*
In channel output mode, press O.C.P to enter into the setting state, at present,
the cursor is flashing in O.C.P current input box, here, you can input needed
current value using number keyboard and then press O.C.P to enable (or disable)
O.C.P protection. If the parameters of O.C.P has already been set, press O.C.P to
directly enable (or disable) O.C.P protection.
Figure 2-11 Set O.C.P
NOTE
 If channel output is disabled, the O.C.P function cannot be enabled but
only for inputting value.
 If the output current beyond the value of overcurrent protection, the
output will be disabled automatically.
 *: Please use O.C.P function as required.