Specifications

RIGOL
Quick Guide for DM3000 series
6
ENGLISH
Power Selection
The Multimeter can operate on multiple power distribution
standards and must be set up to operate on the line voltage that will
power it. If the selected line voltage does not match the power that
the Multimeter will be plugged into, the Multimeter’s linevoltage
setting must be changed. The power selector is under the power
switch on the rear panel.
To change the fuse
The fuse located in the rear panel of the Multimeter, it is a kind of
fast-melt, no-burst, T300mA, 5× 20mm one.
To Change the Fuse
Operation steps:
1． Disconnect the power. Use the Straight Screwdriver to press
down the block (as the dashed line point out), and then pull out
the seat of the fuse.
2． Choose the correct voltage shelves location in the voltage
selected switches.
3． Enclose the seat of the fuse to the slot after placed the fuse.
WARNING: To avoid electric shock or fire, do not use
makeshift fuses or short-circuit the fuse holder.
!