User manual

RIGOL Chapter 2 Command System
2-26 DG800 Programming Guide
*RST
Syntax
*RST
Description
Restores the instrument to its factory default state.
Remarks
 Restores the instrument to its factory default state (please refer to "Factory Setting") and it is not
affected by the
:MEMory:STATe:RECall:AUTO command.
 This command will stop the sweep or burst in progress in an abnormal way.
*SAV
Syntax
*SAV {0|1|2|3|4|5}
Description
Stores the current instrument state in the specified storage location of the internal non-volatile memory
with the default name.
Parameter
Name
Type
Range
Default
{0|1|2|3|4|5}
Discrete
0|1|2|3|4|5
None
Remarks
 The internal memory of the instrument provides 6 storage locations (No. 0 to 5) for the instrument
state. The default sate file name is Scpin.RSF. Wherein, n corresponds to the storage location number.
 If a file is already found in the specified storage location, this command will store the current
instrument state in the specified storage location to directly overwrite the original file.
 For descriptions of the state file, please refer to the "Remarks" under the
*RCL command.
 You can send the
*RCL command to recall the state file stored in the internal non-volatile memory of
the instrument.
Example
*SAV 1 /*Stores the current instrument state in storage location 1 in the internal non-volatile
memory of the instrument with the filename Scpi1.RSF.*/
*SRE
Syntax
*SRE <value>
*SRE?
Description
Enables the bits in the status byte register to generate the service request.
Queries the bits enabled in the status byte register.
Parameter
Name
Type
Range
Default
<value>
Integer
Refer to "Remarks".
None
Remarks
 The parameter <value> is a decimal value corresponding to the binary-weighted sum of the bits