User manual

Ramp 1 μHz to 200 kHz 1 μHz to 500 kHz 1 μHz to 1 MHz
Pulse
1 μHz to 5 MHz
1 μHz to 10 MHz
1 μHz to 10 MHz
Harmonic
1 μHz to 5 MHz
1 μHz to 10 MHz
1 μHz to 15 MHz
PRBS
2 kbps to 10 Mbps
2 kbps to 20 Mbps
2 kbps to 30 Mbps
Dual-tone
1 μHz to 10 MHz
1 μHz to 20 MHz
1 μHz to 20 MHz
RS232
baud rate range: 9600, 14400, 19200, 38400, 57600, 115200, 128000,
230400
Sequence
2 k to 30 MSa/s
Noise (-3 dB)
100 MHz bandwidth
Arbitrary Waveform
1 μHz to 5 MHz
1 μHz to 10 MHz
1 μHz to 10 MHz
Resolution
1 μHz
Accuracy
±(1 ppm of the setting value + 10 pHz), 18℃ to 28℃
2. Select and order the options
DG832/DG822/DG812
For these models, the single-dual channel upgrade option is standard function. You can select and order
the following option according to your need.
Option
Function Description
Order NO.
Memory Depth
Upgrade Option
When this option is installed, DG800 can extend the
memory depth for arbitrary waveforms to 8Mpts.
DG800-ARB8M
USB-GPIB Interface
Converter
You can extend a GPIB interface via the USB HOST
interface on the rear panel of the instrument using this
module. Then, connect the instrument to the PC using a
GPIB cable to realize the communication between the
instrument and PC via the GPIB interface.
USB-GPIB
40 dB Attenuator
Connect the attenuator to the signal output connector to
adjust the output signal voltage.
RA5040K
DG831/DG821/DG811
For these models, the single-dual channel upgrade option and memory depth upgrade option is optional
function. You can select and order the following options according to your need.
Option
Function Description
Order NO.
Single-dual CH
Upgrade Option
When this option is installed, DG831, DG821 and DG811
can be extended into two signal output channels.
DG800-DCH
Memory Depth
Upgrade Option
When this option is installed, DG800 can extend the
memory depth for arbitrary waveforms to 8Mpts.
DG800-ARB8M
USB-GPIB Interface
Converter
You can extend a GPIB interface via the USB HOST
interface on the rear panel of the instrument using this
module. Then, connect the instrument to the PC using a
GPIB cable to realize the communication between the
instrument and PC via the GPIB interface.
USB-GPIB
40 dB Attenuator
Connect the attenuator to the signal output connector to
adjust the output signal voltage.
RA5040K
Note: To install the single-dual channel upgrade option and memory depth upgrade option, you need to get the
corresponding option license. Please acquire the option license according to the following procedures (first, order the desired
option and the option key is provided; then, log in RIGOL website (www.rigol.com), click “License Activation” at the bottom
of the webpage to enter the "Registered product license code" interface; finally, input the option key, instrument serial
number (refer to the User’s Guide to acquire the serial number) and verification code as well as click “Generate” to acquire
the corresponding option license). Then, build the communication between the signal generator and PC and send
the :LICense:SET <license> or :LICense:INSTall <license> command to install the option.
Besides, installing the option by