User manual

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-17
To Output the Arbitrary Waveform
DG800 can output built-in waveforms from a single channel or from two channels at
the same time. The 160 kinds of built-in arbitrary waveforms are stored in the
internal non-volatile memory.
To Enable Arbitrary Waveforms
Press Menu  Continuous  "Arb" to enable arbitrary waveform function and
open the arbitrary waveform selection interface, as shown in the figure below.
Figure 2-4 Arbitrary Waveform Selection Interface
To Select the Waveform
DG800 allows users to select 160 built-in waveforms and arbitrary waveforms stored
in the internal or external memory of the instrument.
Key Points:
After selecting the desired waveform, press the corresponding channel output
control key (Output1 or Output2), and the specified waveform will be output
from the channel. For details, refer to descriptions in "To Enable Channel
Output
". Note that when the f
requency of the arbitrary waveforms is greater than
1 MHz, some waveforms will be distorted.