User manual

Chapter 3 Arbitrary Waveform Output RIGOL
DG4000 User's Guide
3-17
2) Press Execute to apply the setting defined in step 1). The waveform
editor will automatically use straight lines to connect the start point (point
2, the level is 4 V) with the stop point (point 4, the level is -2 V) and
automatically generate point 1 and point 3 to create a continuous
waveform.
3) After finishing editing all the points, press to return to the previous
menu. At this point, press Save to enter the file storage interface (refer to
"
Store and Recall") to save the edited arbitrary waveform.
7. View the edited arbitrary waveform.
V
μs
4
2
0
-2
4 8 12
2
1
3
4
Explanation: As can be seen from the above figure, the waveform editor inserts
values at the start point (point 2) and the stop point (point 4) according to the
current interpolation mode; then, it automatically generates point 1 and point 3 to
create a continuous waveform.