User manual

RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 User's Guide
3-16
Example: Edit Block
The following example introduces how to use "Edit Block" to create an arbitrary
waveform fulfilling the following conditions.
Parameter Value
Cycle Period 12μs
HiLevel 4V
LoLevel -2V
Interp Linear
X1Y1 2, 4V
X2Y2 4, -2V
Operation Procedures:
1. Press Arb and use to open the 2/2 menu page; then press Create New
 Cycle Period, use the numeric keyboard to input "12" and select the unit
"μsec" from the pop-up menu.
2. Press HiLevel, use the numeric keyboard to input "4" and select the unit "V"
from the pop-up menu.
3. Press LoLevel, use the numeric keyboard to input "-2" and select the unit "V"
from the pop-up menu.
4. Press Points, use the numeric keyboard to input "4" and press OK. Note: At
this point, a -2 V level line is displayed.
5. Press Interp to select "Linear".
6. Press Edit Block to enter the "Edit Block" interface.
1) Press X1, use the numeric keyboard to input "2" and press OK. Then,
press Y1, use the numeric keyboard to input "4" and select the unit "V"
from the pop-up menu. Use the same method to set X2 and Y2.