User manual

RIGOL Chapter 2 Basic Waveform Output
DG4000 User's Guide
2-18
indicates current cursor location. Use the numeric keyboard to input the offset
value "5" and select the unit "mV
DC
" from the pop-up menu.
6. Press Width/Duty to highlight "Width". The lightspot above the number
indicates current cursor location. Use the numeric keyboard to input "200"
and select the unit "nsec" from the pop-up menu. At this point, the pulse duty
cycle changes accordingly.
7. Press Leading to highlight it. The lightspot above the number indicates
current cursor location. Use the numeric keyboard to input "75" and select the
unit "nsec" from the pop-up menu.
Press Trailing to highlight it. The lightspot above the number indicates
current cursor location. Use the numeric keyboard to input "100" and select
the unit "nsec" from the pop-up menu.
8. Press Output1 at the front panel to turn the CH1 output on. At this point, the
instrument outputs the specified waveform from CH1 according to the current
configuration. Connect the output terminal of CH1 to the oscilloscope and the
waveform is as shown in the figure below.
Figure 2-4 To Output Pulse Waveform