User manual

RIGOL Chapter 2 Basic Waveform Output
DG4000 User's Guide
2-16
To Enable the Channel Output
After configuring the parameters of the waveform selected, waveform output
could be enabled.
Note: Before enabling the channel, you can also configure the parameters (such as
the resistance and polarity) related to the output of the corresponding channel
through the channel setting menu (CH1Set or CH2Set) in Utility. For the details,
please refer to the introduction in "Channel Setting".
Press Output1 or/and Output2 at the front panel and the backlight of the button
turns on. The instrument outputs the configured waveform from the [Output1]
or/and [Output2] connector at the front panel.