User manual

Chapter 2 Basic Waveform Output RIGOL
DG4000 User's Guide
2-1
Chapter 2 Basic Waveform Output
DG4000 can output basic waveforms (including Sine, Square, Ramp, Pulse and
Noise) from one of the channels separately or from the two channels at the same
time. At start-up, the channel is configured as a sine waveform with 1kHz
frequency and 5Vpp amplitude by default. This chapter introduces how to
configure the instrument to output various basic waveforms.
Subjects in this chapter:
 To Select the Channel
 To Select Basic Waveform
 To Set the Frequency
 To Set the Amplitude
 To Set the DC Offset Voltage
 To Set the Start Phase
 Align Phase
 To Set the Duty Cycle
 To Set the Symmetry
 To Set the Pulse Parameters
 To Enable the Channel Output
 Basic Waveform Output Example