User manual

RIGOL Chapter 11 Remote Control
DG4000 User's Guide
11-6
Remote Control via LAN
1. Connect the device
Connect the signal generator to your LAN using a network cable.
2. Configure the network parameters
Configure the network parameters of the signal generator according to "LAN
Setting".
3. Search for device resource
Start up Ultra Sigma and click
to open the panel as shown in figure
below. Click
and the software will search for the instrument
resource currently connected to the LAN; the resource found is displayed at
the right of the panel. Click
to add the resource. Note: If you
want to remove the unwanted resource, click the corresponding resource
name and click
.
4. View the device resource
The resource found will appear under the "RIGOL Online Resource" directory.
For example, DG4162 (TCPIP::172.16.3.190::INSTR).
5. Control the instrument remotely
Right click the resource name "DG4162 (TCPIP::172.16.3.190::INSTR)" to
select "SCPI Panel Control" to open the remote command control panel
through which you can send commands and read data.