User manual

RIGOL Chapter 11 Remote Control

DG4000 User's Guide

11-2

Remote Control via USB

1. Connect the device

Connect the signal generator (USB Device interface) with your PC using a USB

cable.

2. Install the USB driver

This signal generator is a USBTMC device. After you connect the signal

generator to the PC and turn on the signal generator for the first time (the

signal generator is automatically configured to USB interface; at the same

time, make sure that Utility  I/O Config  USB Dev is set to "PC"), the

Found New Hardware Wizard dialog box as shown in the figure below is

displayed on the PC. Please install the "USB Test and Measurement Device

(IVI)" driver following the directions in the wizard. The steps are as follows.