User manual

Chapter 10 Utility Functions and System Settings RIGOL

DG4000 User's Guide

10-19

Users could store the contents displayed on the screen into external USB storage

device in picture format or print them via PictBridge printer. Press Utility  Print

Set to open the print setting interface.

1. Print the screen using PictBridge printer

First, connect the pictBridge printer. Connect the USB Device interface of the

signal generator to the USB Host interface of the Printer using USB cable (as

shown in the figure below).

Press Utility  I/O Config  USB Dev to set the device type to "Printer".

Press Utility  Print Set Dest to select "Printer". Then, press Printer

Set to enter the print setting menu.

 Copies: press this softkey and use the knob to input the number of

copies to be printed. The range is from 1 to 1000.

 Palette: press this softkey to set the color of the image to "Gray" or

"Color".

 Inverted: press this softkey to enable or disable inverted print.

2. Store the screen to USB Storage Device

Please connect a USB storage device first. When the connection succeeds, an

icon will be displayed in the status bar on the screen and the

corresponding prompt message will be displayed.

Press Utility  Print Set Dest to select "UsbDisk" and then press

Format to set to store the screen picture in "Bmp" or "Jpeg" format.

3. Execute the print operation

Press Print at the front panel and the generator will print the screen via the

PictBridge printer or store the screen in the folder named as "Rigol" (if this

DG4000

PictBridge Printer

USB Host USB D

evice

USB Cable