User manual

Chapter 10 Utility Functions and System Settings RIGOL
DG4000 User's Guide
10-15
System Setting
Number Format
You can set the display formats of the decimal point and thousands separator in
number parameters. This setting is stored in non-volatile memory. Press Utility 
System  Number Format to enter the number format setting interface.
 Decimal Point: could be set as dot "." or comma "," and the default is dot ".".
 Separator: when the decimal point is set to ".", the separator can be set to ",",
"Space" or "None".
When the decimal point is set to ",", the separator can be set to ".",
"Space" or "None".
Number format has 6 combinations, as shown in the figure below.
Dot + Comma
Dot + Space
Dot + None
Comma + Dot
Comma + Space
Comma + None
Note: The decimal point and separator cannot be both set as dot or comma at the
same time.