User manual

RIGOL Chapter 8 Counter
DG4000 User's Guide
8-2
To Enable the Counter
Press Counter at the front panel (the backlight of the key turns on) to enable
counter function and enter counter setting interface as shown in the figure below.
If the counter is currently turned on and the screen displays the counter interface,
pressing Counter will disable the counter function. If the counter is currently
turned on and the screen displays interfaces other than the counter interface,
pressing Counter will switch to the counter interface.
Figure 8-1 Counter Parameter Setting Interface
No. Description No. Description
1 Gate Time 8 Running Status
2 Coupling 9 Statistic Length (Frequency)
3 Attenuation 10 Statistic Length (Period)
4 High-frequency
Suppression
11 Statistic Length (Duty Cycle)
5 Input Impedance 12 Statistic Length (Positive Pulse Width)
6 Trigger Sensitivity 13 Statistic Length (Negative Pulse Width)
7 Trigger Level 14 Statistic Trigger Condition
Note: The CH2 sync output will be disabled when the counter is enabled.
1 2 3 4 5 6 7 8
9 10 11 12 13 14