User manual

Chapter 7 Burst RIGOL
DG4000 User's Guide
7-3
When Burst is enabled, press Type to select "N Cycle". The parameter "Cycles"
on the screen is highlighted and could be edited. At this point, use the numeric
keyboard or the direction keys and knob to change the number of cycles; the
default is 1 and the settable range is from 1 to 1 000 000 (external trigger or
manual trigger) or 1 to 500 000 (internal trigger).
Figure 7-1 N Cycle Burst
Infinite Burst
In Infinite mode, the cycle number of the waveform is set as an infinite value. The
generator outputs a continuous waveform after receiving trigger signal. Waveform
functions that support infinite burst include Sine, Square, Ramp, Pulse and
arbitrary waveform (except DC).
For infinite burst, "Ext" or "Manual" trigger source could be used. Besides, users
can set the "Start Phase", "Delay", "SlopeIn" (external trigger) and "TrigOut"