User manual

RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 Series Users Guide
3-14
1) Press PointID to define the first point (the time is 0 by default). Press
Voltage, use the numeric keyboard to input 0 and select the unit V
from the pop-up menu.
2) Press PointID again, use the numeric keyboard or knob to select point 2;
then press Time and Voltage to input 4μs and 4 V respectively.
3) Refer to step 2) to input point 3 and 4 in the table.
4) After finishing editing all the points, press OK to return to the previous
menu. At this point, press Save to enter the file storage interface (refer to
Store and Recall) to save the edited arbitrary waveform.
7. Observe the edited arbitrary waveform.
4 8 12
2
4
μs
0
1
4
3
2
1
-2
V
Explanation: as shown in the figure above, the waveform editor will
automatically set the voltage of the last point to that of point 1 to create a
continuous waveform.