User manual

RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 Series Users Guide
3-2
To Enable Arbitrary Waveform
Press Arb to enable arbitrary waveform function and open the operation menu of
arbitrary waveform.
1. Freq/Period: set the output “Frequency/Period of the arbitrary waveform.
2. Ampl/HiLevel: set the output Amplitude/High Level of the arbitrary
waveform.
3. Offset/LoLevel: set the output “Offset/Low Level” of the arbitrary waveform.
4. Phase: set the Start Phase” of the arbitrary waveform.
5. Align Phase: refer to Align Phase.
6. Step-By-Step: enable the step-by-step output mode of arbitrary waveform.
7. Select Wform: select arbitrary waveform stored in internal or external
memory.
8. Create New: users can define waveform with up to 16 kpts.
9. Edit Wform: edit the stored arbitrary waveform.
Refer to Basic Waveform Output to configure the parameters and output. This
chapter will focus on Step-By-Step, “Select Waveform, “Create New” and “Edit
Waveform.
Tip
Users can also press User at the front panel to quickly set arbitrary waveform
parameters including frequency/period, amplitude/high level, offset/low level,
start phase and align phase. At this point, the waveform output is the waveform
defined in Utility UserKey (refer to introduction in User-defined
Waveform Key).