User manual

RIGOL Chapter 1 Quick Start
DG4000 Series Users Guide
1-18
3. Channel Status
Display areas of CH1 and CH2. Indicate whether the channel is selected and
turned on (ON/OFF).The area of the channel currently selected is highlighted
and the on/off state of the channel currently turned on is ON.
Note:
When a channel is Selected, it does not mean that the channel is turned on.
When CH1 is selected, users can configure the parameters of CH1 and the
backlight of CH1 turns on. When CH1 is turned on, CH1 can output waveform
according to the current configuration and the backlight of Output1 turns on.
4. Channel Configurations
Display the current output configuration in each channel, including output
resistance, mode and type of modulating source or trigger source.
Output Resistance
High Impedance: display HighZ
Load: display the resistance value, the default is 5
Mode
Modulation: display Mod
Sweep: display Sweep
Burst: display Burst
Modulating/Trigger Source Type
Internal modulating/trigger: display Internal
External modulating/trigger: display External
Manual Trigger: display Manual
5. Frequency
Display the current waveform frequency in each channel. Press the
corresponding softkey Freq and use the numeric keyboard or direction keys
and knob to modify this parameter. The parameter that can be modified
currently will be highlighted and the lightspot above the number indicates
current cursor location.
6. Amplitude
Display the current waveform amplitude in each channel. Press the
corresponding softkey Ampl and use the numeric keyboard or direction keys
and knob to modify this parameter. The parameter that can be modified