User manual

RIGOL Chapter 10 Utility and System Settings
DG4000 Series Users Guide
10-14
Brightness
Press Utility System Light and use the numeric keyboard or knob to set
the brightness of the screen. The range is from 1% to 100%. This setting is stored
in non-volatile memory and will not be influenced by Preset.
Beeper
When the beeper in DG4000 is enabled, a beep is generated when an error occurs
during front panel or remote operation.
Press Utility System Beep to select On or Off and the default is On.
The current setting is stored in non-volatile memory and will not be influenced by
Preset.
Screen Saver
Enable or disable screen saver mode.
Press Utility System ScrnSvr to select On or Off and the default is
Off. The current setting is stored in non-volatile memory and will not be
influenced by Preset.
Clock Source
DG4000 provides internal 10MHz clock source and accepts external clock source
from the [10MHz In/Out] connector at the rear panel. It can also output clock
source from the [10MHz In/Out] connector.
Press Utility System CLK to select Int or Ext. The default is Int. If