User manual

Chapter 10 Utility and System Settings RIGOL
DG4000 Series Users Guide
10-11
To Set Domain Name
Consult your network administrator whether you need to use a domain name and
what is the name.
Press Domain Name and use the numeric keyboard and direction keys to enter
the domain name with up to 16 characters which could consist of letters, numbers,
dot and dash. The setting is stored in the non-volatile memory.
Default Configuration
Press Default Config and the prompt message Restore network settings to
preset values of LXI? is displayed. Press OK to restore the network parameters to
their default values. By default, DHCP and AutoIP are enabled and ManualIP is
disabled.
Current Configuration
Press Current Config to examine the MAC address of the current instrument, the
current LAN parameters and LAN status information.
OK
Press Ok to enable the current setting of LAN parameters.
To Set USB Device Type
The USB Device interface at DG4000 rear panel could be connected with PC to
control the instrument remotely.
Press Utility I/O Setup USB Dev to select PC. Users can use PC software
to edit arbitrary waveform and download it to the internal memory of the generator.
Users can also use the SCPI commands to control the generator.