User manual

Chapter 6 Sweep RIGOL
DG4000 Series Users Guide
6-9
Figure 6-4 Mark Frequency
Start Hold
Start Hold is the duration that the output signal outputs with the Start Frequency
after the sweep starts. After the Start Hold, the generator will output with varying
frequency in the current sweep type.
When Sweep is enabled, use to open the 2/2 menu page, then press Start
Hold and use the numeric keyboard or knob to change the Start Hold. The default
value is 0s and the available range is from 0s to 300s.
The generator will renewedly sweep and output from the specified Start
Frequency once the Start Hold is changed.