Instructions

Chapter 1 Quick Guide RIGOL
DG2000 User Guide 1-5
5. Channel Control Area
It is used to control the output of CH1.
— Press this key to enable the output of CH1, the backlight
turns on. At this time, the [CH1] connector outputs the
waveforms according to the current configuration of CH1.
— Press this key again to disable the output of CH1, and the
backlight turns off.
It is used to control the output of CH2.
— Press this key to enable the output of CH2, the backlight
turns on. At this time, the [CH2] connector outputs the
waveforms according to the current configuration of CH2.
— Press this key again to disable the output of CH2, and the
backlight turns off.
6. CH2 Output Connector
BNC connector, with 50 Ω nominal output impedance.
When Output2 is enabled (the backlight turns on), this connector outputs
waveforms according to the current configuration of CH2.
7. Counter Measurement Signal Input Connector
BNC connector, with 1 MΩ input impedance. It is used to receive the signal
measured by the counter.
8. Frequency Counter
Enables or disables the frequency counter.
— Press this key to enable the frequency counter, and the backlight turns on
and blinks continuously.
— Press this key again to disable the frequency counter, and the backlight
turns off. At this time, the frequency counter is disabled.
Note: When the frequency counter is enabled, no waveforms will be output
from the CH2 connector. When the frequency counter is disabled, waveforms are
allowed to be output from the CH2 connector.
9. Arrow Key
— It is used to move the cursor to select the digit to be edited when you use
the knob to set the parameters (pressing down the knob can enter the
editing mode).
— In the user interface, it is used to move left or right the cursor.
10. Knob
— When you select a menu label in the interface, the knob can be used to
CAUTION
To avoid damages to the instrument, the input signal voltage cannot
exceed ±5 V.