Manualshelf

Instructions

ManualsBrandsRigol ManualsFunction GeneratorsRigol DG2052 Mains-powered 0.000001 Hz - 50 MHz 2-channel Sinus, Rectangle, Noise, Pulse, Triangle, Arbitrary
12345678910
RIGOL Chapter 1 Programming Overview
1-2 DG2000 Programming Guide
Build Remote Communication
You can build the remote communication between DG2000 and the PC via the USB (USB DEVICE), LAN, or
GPIB interface (extended from the USB HOST interface by using the USB-GPIB interface converter).
Operation Procedures:
1. Install Ultra Sigma (PC) software
Download the Ultra Sigma common PC software from www.rigol.com and install it according to the
instructions.
2. Connect the analyzer to the PC and configure the interface parameters for the instrument
DG2000 supports the USB, LAN, and GPIB (extended from the USB HOST interface by using the
USB-GPIB interface converter) communication interfaces, as shown in the figure below.
Figure 1-1 DG2000 Communication Interface
1) Use the USB interface: connect the USB DEVICE interface on the rear panel of DG2000 and the
USB HOST interface of the PC by using a USB cable. The "Found New Hardware Wizard" dialog
box will be displayed and please install the "USB Test and Measurement Device (IVI)" according to
the instructions (refer to "Remote Control via USB" in Chapter 3 "Remote Control" in
DG2000 User
Guide
).
2) Use the LAN interface:
Make sure that your PC has been accessed to the local area network.
Check whether the local area network where your PC resides supports DHCP or auto IP mode.
If not, you need to acquire the network interface parameters available, such as the IP
address, subnet mask, default gateway, and DNS.
Use the network cable to have DG2000 get access to the local area network.
When the Shift key is illuminated, press Pulse/Utility Interface LAN to configure
the IP address, subnet mask, default gateway, and DNS.
3) Use the GPIB interface:
Extend a GPIB interface by connecting the USB HOST interface on the front panel of DG2000
by using the USB-GPIB interface converter.
Use the GPIB cable to connect the instrument to your PC.
When the Shift key is illuminated, press Pulse/Utility Interface GPIB to set the
GPIB address of the instrument.
3. Check whether the connection is successful
Run Ultra Sigma, and then search for the resources and right-click the resource name. Select "SCPI
Panel Control" to open the SCPI command control panel. Input a correct command in the pop-up SCPI
control panel and click
and in sequence or directly click
USB DEVICE
LAN