Instructions

RIGOL Chapter 2 Command System
2-54 DG2000 Programming Guide
Remarks
 When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
 The range of <amp> is limited by the "Impedance" (
:OUTPut[<n>]:IMPedance
or
:OUTPut[<n>]:LOAD) and "Frequency/Period" settings. The range of <offset> is limited by the
"Impedance" and "Amplitude/High Level" settings.
Example
:SOUR1:APPL:RS232 1,2 /*Sets the waveform of CH1 to RS232 with 1 Vpp amplitude and 2 V
dc
offset.*/
[:SOURce[<n>]]:APPLy:SEQuence
Syntax
[:SOURce[<n>]]:APPLy:SEQuence
[{<sample_rate>|DEFault|MINimum|MAXimum}[,{<amplitude>|DEFault|MINimum|MAXimum}[,{<offset
>|DEFault|MINimum|MAXimum}[,{<phase>|DEFault|MINimum|MAXimum}]]]]
Description
Sets the waveform of the specified channel to sequence waveform with the specified sample rate,
amplitude, offset, and start phase.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<sample_rate>
Real
2 kSa/s to 60 MSa/s
1 MSa/s
<amplitude>
Real
Refer to "Remarks".
5 Vpp
<offset>
Real
Refer to "Remarks".
0 V
dc
<phase>
Real
0° to 360°
0°
Remarks
 When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
 This command only selects and sets the sequence waveform parameters of the channel.
 The range of <amplitude> is limited by the "Impedance" (
:OUTPut[<n>]:IMPedance
or
:OUTPut[<n>]:LOAD) setting. The range of <offset> is limited by the "Impedance" and
"Amplitude/High Level" settings.
Example
:SOUR1:APPL:SEQ 10000,1,2,1 /*Sets the waveform of CH1 to Sequence with 10 kSa/s sample rate, 1
Vpp amplitude, 2 V
dc
offset, and 1° start phase.*/
[:SOURce[<n>]]:APPLy:SINusoid
Syntax
[:SOURce[<n>]]:APPLy:SINusoid
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum[,<offset>|DEFault|MINimu
m|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Sets the waveform of the specified channel to Sine with the specified frequency, amplitude, offset, and
phase.