Instructions

RIGOL Chapter 2 Command System
2-148 DG2000 Programming Guide
Description
Sets the subnet mask.
Queries the subnet mask.
Parameter
Name
Type
Range
Default
<mask>
ASCII String
Refer to "Remarks".
None
Remarks
 This command is only valid when the ManualIP configuration mode
(
:SYSTem:COMMunicate:LAN:STATic[:STATe]) is enabled.
 The format of <mask> is "nnn.nnn.nnn.nnn". The range of "nnn" is from 0 to 255. You are
recommended to ask your network administrator for a subnet mask available.
 After sending this command, the new settings will only take effect when
the
:SYSTem:COMMunicate:LAN:APPLy command is executed to apply the current network
parameters.
 The subnet mask must be continuous, that is, 1 and 0 must be continuous.
Return Format
The query returns a string. For example, 255.255.255.0.
Example
:SYST:COMM:LAN:SMAS 255.255.255.0 /*Sets the subnet mask to 255.255.255.0.*/
:SYST:COMM:LAN:SMAS? /*Queries the subnet mask and the query returns 255.255.255.0.*/
:SYSTem:COMMunicate:LAN:STATic[:STATe]
Syntax
:SYSTem:COMMunicate:LAN:STATic[:STATe] {ON|1|OFF|0}
:SYSTem:COMMunicate:LAN:STATic[:STATe]?
Description
Enables or disables the manual IP configuration mode.
Queries the status of the manual IP configuration mode.
Parameter
Name
Type
Range
Default
{ON|1|OFF|0}
Bool
ON|1|OFF|0
OFF
Remarks
 In ManualIP mode, the network parameters of the generator, e.g. IP address, are defined by users.
 If all the three IP configuration modes are set to "On", the priority of parameters configuration from
high to low is "DHCP", "AutoIP", and "ManualIP". Therefore, to enable the ManualIP mode, set DHCP
and AutoIP to "Off".
 The three IP configuration modes cannot be set to "Off" at the same time.
 After sending this command, the new settings will only take effect when
the
:SYSTem:COMMunicate:LAN:APPLy command is executed to apply the current network
parameters.
Return Format
The query returns ON or OFF.
Example
:SYST:COMM:LAN:STAT ON /*Enables the ManualIP configuration mode.*/
:SYST:COMM:LAN:STAT? /*Queries the status of the ManualIP configuration mode and the query
returns ON.*/