User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
2-40
1. N-Cycle/ Gated
N-Cycle has specific number of waveform cycles, and every burst is activated by a
trigger event. Gated burst use external source to control burst when to be
activated.
2. Cycle Number
Set the number of Waveform Cycle in an N-Cycle (1 to 50,000 or Infinite).
If you choose Infinite, then a continuous waveform will be generated.
 If needed, Burst Period will increase to cater to the specific number of cycles.
 For an infinite-cycle Burst, External or Manual Trigger is needed to activate
burst. To stop the infinite burst, press Manual again.
3. Phase
Define the Start and the Stop Point in a waveform. The phase varies from -180°
to +180°, and the default setting is 0°. For an Arbitrary Waveform, 0° is the
phase of the first waveform point.
4. Period
Set the time span between an N-Cycle Burst to the next. If necessary the period
will increase to allow the specific number of cycles in a burst.
Burst Period> Period X Burst Number
5. Delay
Set the Time Delay between the Trigger Input and the Start of the N-Cycle Burst.
The minimum delay is a function of the specific burst period, and should always
be greater than (or equal to) 0.
Press View, in the Graph Mode, the waveform is shown in the following figure.
Figure 2-46
Waveform Parameter in the Graph Mode
Start Phase
Burst Period
Cycle Times
Delay
N-Cycle