User`s guide

RIGOL

User’s Guide for DG10× 2 Series

Table 2-15 Setting the FM parameters

Settings

Explanation

Type

FSK

Choose Frequency Shift Keying Modulation

SrcInt

HopFreq

Set the Hop Frequency Range

(Internal Source: Square with 50% duty

cycle)

FSK Rate

Set the frequency at which the output

frequency shifts between the carrier

frequency and the jumping frequency:

2mHz～50kHz.

SrcExt

HopFreq

Choose External modulation, the

modulating waveform is inputted form the

[Ext Trig/FSK/Burst] port on the rear

panel. Only “HopFreq” needs to be set.

Press View, in the Graph Mode, the waveform is shown in the following figure.

Figure 2-40

Waveform Parameter in the Graph Mode

FSK Frequency

Hop Frequency