User`s guide

RIGOL

User’s Guide for DG10× 2 Series

1. To Set the Point Number

 Press Points, set the number of the initializing points.

Figure 2-27

Set the points of the editing waveform

 When a new waveform is created, the waveform editor will firstly create a

waveform with two points. The Waveform Editor connects the last point to the

Voltage Level of point #1 to create a continuous waveform automatically. A

waveform with at most 4K points can be created.

 In the default setting, point #1 is Level High, fixed on 0 second, while point #2 is

Level Low and on the half of the set Cycle period.

2. To Set the Interpolation

Press Interp., if you choose Interpolation On, and the points will be connected

with beelines; otherwise, the voltages between the two consecutive points will

not change and the waveform looks like a step-up one.

3. To Edit the Waveform Points

Press Arb  Edit  Create  EditPt, The waveform can be defined by setting the

time and voltage for each point using this function. The interface is as follows:

Figure 2-28

Operation Menu