User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
2-6
To Set the Initial Phase
1. Press Sine  Phase, to set the initial phase.
The phase shown on the screen is the default value when the instrument is
powered or the set value beforehand. When changing the function, if the current
value is valid for the new waveform, it will be used sequentially.
2. Input the desired Offset
Use the keypad or the knob to input the desired value, choose the unit, and press
the corresponding button.
Figure 2-5
Setting the initial phase
After finishing the above operations, press View , in the Graph Mode, the waveform is
shown in the following figure.
Figure 2-6
Waveform Parameter in the Graph Mode
Current Parameter:
Phase