User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
2-4
To Set the Output Amplitude
1. Press Sine  Ampl/HiLev  Ampl, to set the amplitude.
The amplitude shown on the screen is the default value when the instrument is
powered or the set value beforehand. When changing the function, if the current
value is valid for the new waveform, it will be used sequentially. If you want to set
the waveform by high Level or Low Level, press Ampl/HiLev or Offset/Lolev again,
switch to HiLev or LoLev parameter (The current operation is displayed in inverse
color).
2. Input the desired Amplitude
Use the keypad or the knob to input the desired value, choose the unit, and press
the corresponding button.
Figure 2-3
Setting the Amplitude
NOTE:
The “dBm” option will appear only when the output impedance is set to “50”.
Current Parameter:
Amplitude