User`s guide

RIGOL

User’s Guide for DG10× 2 Series

1-12

To Set Modulate/Sweep/Burst

As shown in the following figure, there are three buttons on the front panel, which are

used for Modulation, Sweep and Burst settings. The instructions below will help you to

be familiar with the settings of these functions.

Figure 1-17

Modulate/ Sweep/ Burst button

NOTE: Mod, Sweep and Burst functions are only used for CH1.

1. Press the Mod button, and a Modulated waveforms will be generated.

Parameters are set by using the menu buttons. The modulated waveform can be

changed by changing the parameters such as Type, Internal/external Modulation,

Depth, Frequency, Waveform, etc.

DG10× 2 Series can modulate waveform using AM, FM, PM and FSK. Sine, Square,

Ramp or Arbitrary waveforms can be modulated (Pulse, Noise and DC cannot be

modulated).

Figure 1-18

Modulated Waveform Signal in the Menu Display Mode

2. Press the Sweep button, Sine, Square, Ramp or Arbitrary waveform can be swept

(Pulse, Noise and DC can not be swept).

In the Sweep Mode, DG10× 2 Series generate signal with variable frequencies.