User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
1-9
As shown in Figure 1-12, the default signal parameters are: 1kHz Frequency,
5.0VPP Amplitude, 0 VDC Offset, 50% Duty Cycle, 500μs Pulse Width and 0s Delay.
5. Press the Noise button, a “Noise” typeface will display in the state area. The
instrument can generate Noise signal with Band Width up to 5MHz. By setting
Amplitude/High Level, Offset/Low level , Noise signal with different parameters can
be generated.
Figure 1-13
Noise Signal in the Menu Display Mode
As shown in Figure 1-13, the default signal parameters are: 5.0 VPP Amplitude
and 0 VDC Offset.
6. Press the Arb button, an “Arb” typeface will display in the state area. The
instrument can generate repeatable arbitrary waveform signals with at most 4K
points and 5MHz frequency. By setting Frequency/Period, Amplitude/ High Level,
Offset/ Low level and Phase , arbitrary waveform signals with different parameters
can be generated.
Figure 1-14
Arbitrary waveform Signal in the Menu Display Mode
As shown in Figure 1-14, the default Exponential Rise Signal parameters are:
1kHz Frequency, 5.0 VPP Amplitude, 0 VDC Offset and 0° initial phase.