User`s guide

RIGOL

User’s Guide for DG10× 2 Series

4-6

the corresponding lower limit.

5. Amplitude(Vpp)upper limit=***VPP

Different modes have different amplitude upper limits; amplitude upper limit may

vary in the same mode if the load settings are different.

6. Amplitude(Vrms)upper limit=***VRMS

Different modes have different amplitude upper limits; amplitude upper limit may

vary in the same mode if the load settings are different.

7. Amplitude(Vpp)Lower limit=***VPP

Different modes have different amplitude lower limit; amplitude lower limit may

vary in the same mode if the load settings are different.

8. Amplitude(Vrms)Lower limit=***VRMS

Different modes have different amplitude lower limit; amplitude lower limit may

vary in the same mode if the load settings are different.

9. High Level upper limit***V

Different modes have different High Level upper limit; High Level upper limit may

vary in the same mode if the load settings are different.

10. Low Level lower negative limit=***V

Different modes have different High Level lower limit; High Level lower limit may

vary in the same mode if the load settings are different.

11. Offset upper limit=***V

Different modes have different Offset upper limit; Offset upper limit may vary in

the same mode if the load settings are different.

12. Offset lower negative limit=***V

Different modes have different Offset lower limit; Offset lower limit may vary in

the same mode if the load settings are different.

13. Duty Cycle upper limit=***%

In Square mode, different frequency range corresponds to different Duty Cycle

limit.

For a frequency lower than 3 MHz (include), the range is from 20% to 80%;

For a frequency between 3~4 MHz (include), the range is from 40% to 60%;

For a frequency between 4~5 MHz, the Duty Cycle is set to be 50%.

14. Duty Cycle lower limit=***%

In Square mode, different frequency range corresponds to different Duty Cycle