User`s guide

RIGOL

User’s Guide for DG10× 2 Series

4-2

Prompting Messages

Common Messages

1. Need Help? Press and hold down any key. Settings are restored from

last power-down. Selected interface is USB.

When the instrument is powered, this message will appear to inform users that all

the settings have been restored and you can operate the instrument normally.

The instrument detected current I/O is USB, and informs the user that no new

USB device is detected.

2. No changes.

When the waveform parameter is being altered, if the user cancels the operation,

the message will prompt.

3. Selected Arb is ***.

Press Arb, this message will appear to inform users that the default selection of

arbitrary waveform type is “***”.

4. First, set the all over waveform parameters.

To inform the user, set the general waveform parameter first. Then set the

parameters for each point.

5. Editing the existing waveform parameters.

Perform the waveform edit operation, and inform the user that operation can be

taken to edit the current waveform parameter.

6. Trigger ignored-OUTPUT is off.

When the OUTPUT is disabled, the Trigger Output will be disabled automatically.

7. Instrument is triggered.

Press Sweep / Burst  Trigger  Source Manual, this message will appear to

inform users that the instrument has performed a trigger.

8. Trigger source changes to Ext/Manual.

Only when the External or Manual Trigger Source is selected, the infinite burst is

allowed.