User`s guide

RIGOL

User’s Guide for DG10× 2 Series

3-20

Example for Channel Coupling

Choose CH1 as the base channel, set the phase deviation to be 10°, view the

waveforms before and after the coupling.

The operation steps:

1. Set the parameters of CH1 as shown in the following figure: Sine wave, frequency

1 kHz, amplitude 5V

, Offset 0 V

, phase 0°.

Figure 3-18

Parameters Setting in CH1

2. Set the parameters of CH2 as shown in the following figure: Ramp wave,

frequency 1.5 kHz, amplitude 5V

, Offset 0 V

, phase 0°.

Figure 3-19

Parameters Setting in CH2

3. Press Utility  Coupling  Switch  “Coupling On”. Open the coupling function.

4. Press BaseCH  “Channel_1”. Choose CH1 as the base channel.

5. Press PhaDev, use the keypad to input “10” and choose the unit of “°”. Set the

phase deviation to be 10°.

6. Press to save the exit the coupling setting. Press View, in the Graph Mode,

you will see the phase of CH2 has been changed to 10°.