User`s guide

RIGOL

User’s Guide for DG10× 2 Series

3-13

Example 10: To Generate a Linear Sweep Waveform

How to generate a Sine Sweep Waveform whose frequency starts from 100Hz to

10kHz. Use the Internal Trigger Mode, Linear Sweep, and the Sweep is 1s.

The operation steps:

1. Choose the Sweep Function.

Press Sine, and choose the Sine Waveform as the Sweep Function.

The default setting of the Source is Internal.

2. Set the Parameters of the Sweep Function.

Use the default values. You can view all the parameters in the Graph mode.

3. Set the Sweep Mode.

Press Mod  Linear/Log and choose Linear. Please notice that the message

shown on the top left side of the screen is “Linear”.

4. Set the Sweep Time.

Press Time, use the keypad to enter “1”, choose the unit “s”, to set the Sweep

Time as 1s.

5. Set the Start Frequency.

Press Start, use the keypad to enter “100”, choose the unit “Hz”, to set the Start

Frequency as 100Hz.

6. Set the Stop Frequency.

Press Stop, use the keypad to enter “10”, choose the unit “kHz”, to set the Stop

Frequency as 10 kHz.

After finishing the above settings, the instrument generates the specified Sweep

waveform whose frequency starts from 100Hz and stops at 10 kHz. press View, the

Waveform is shown in Figure 3-11.