User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
3-3
Example 2: Output a Square Waveform
How to generate a Square waveform with 1MHz Frequency, 2 VRMS Amplitude, 10m
VDC Offset, 30% Duty Cycle and 30° phase.
The operation steps:
1. Set the Frequency.
(1) Press Square  Freq/Period  Freq which will display in reverse color.
(2) Enter “1” from the keypad and choose the unit “MHz” to set the Frequency as
1MHz.
2. Set the Amplitude.
(1) Press Ampl/HiLev  Ampl which will display in reverse color.
(2) Enter “2” from the keypad and choose the unit “VRMS” to set the Amplitude as 2
VRMS.
3. Set the Offset.
(1) Press Offset/LoLev  Offset which will display in reverse color.
(2) Enter “10” from the keypad and choose the unit “mVDC” to set the Offset as 10m
VDC.
4. Set the Duty Cycle.
(1) Press DtyCyc which will display in reverse color.
(2) Enter “30” from the keypad and choose the unit “%” to set the Duty Cycle as 30%.
5. Set the Initial Phase.
(1) Press Phase which will display in reverse color.
(2) Enter “30” from the keypad and choose the unit “°” to set the Phase as 30°.
After finishing the above settings, press View, the generated waveform is shown in
Figure 3-2.
Figure 3-2
Square Waveform Output