User`s guide

RIGOL

User’s Guide for DG10× 2 Series

2-74

1. View the last message display

View the last message display.

2. View the remote Command error queue

View the remote command error queue in the remote operation.

3. Get HELP on any key

To get context-sensitive help on any front-panel key or menu soft key, press and

hold that key for a few times.

4. Generate a modulated Waveform

(1) Configure the Carrier waveform by selecting the waveform shapes, frequency,

amplitude, etc.

(2) Configure the modulating waveform by pressing the Mod button.

(3) To change the Carrier parameter, press the lighted function button (Sine, Square

etc).

(4) To turn off the modulation, press the lighted Mod button.

5. Create an arbitrary waveform

(1) Press Arb  Edit Create.

(2) Enter the desired period, voltage limit, and the number of points and then press

“Edit Pt”, the first two points have defined for you.

(3) Rotate the knob to select the desired point for editing and then use Time and

Voltage to define the point. Press Insert to insert additional points as needed.

(4) The waveform editor connects the last point to the voltage level of point #1 to

create a continuous waveform. Make sure that the time value of the last point less

than the specified period.

(5) Press Save to store the waveform and exit the waveform editor.

6. Generate DC signal

To output the DC signal, press Arb  Load  BuiltIn  Others  “DC”  Select,

and you can adjust the DC offset.

7. Reset instrument to its default state

(1) Press Utility to enter the utility function.

(2) Choose System  Setting.

(3) Select Default to reset the instrument as its default state.

8. RIGOL Technology Support

To obtain technical support, contract the local RIGOL Support Center or go to

RIGOL website: www.rigolna.com