Specifications

DG10X2 Commands System RIGOL
Programming Guide for DG10X2
2-49
DATA
DATA commands are usd for editing or saving arbitrary waves and outputing those
waves via CH1. You can store ten user-defined waveforms at most in non-volatile
memory in addition to one in volatile memory. Each waveform can contain data points
within 1 and 524,288 (512k).
DG10X2 supports following DATA commands:
1. DATA
2. DATA:DAC
3. DATA:COPY
4. DATA:DELete
5. DATA:CATalog?
6. DATA:RENAME
7. DATA:NVOLatile:CATalog?
8. DATA:NVOLatile:FREE?
9. DATA:ATTRibute:POINts?
10. DATA:LOAD
The detailed information of each command are:
1. DATA
Command
Format
DATA VOLATILE,<value>, <value>, . . .
Function
Load the floating point numbers between -1 and 1 into volatile
memory.
Explanations
 DATA command may cover a previous waveform in volatile
memory (does not generate error).
 Use DATA:COPY command to copy the waveform to
non-volatile memory.
 Use DATA:DELete command to delete the waveform in
volatile memory or any of the ten user-defined waveforms in
nonvolatile memory.
 Use DATA:CATalog? command to list all waveforms currently
stored in volatile and non-volatile memory.
 Use FUNCtion:USER command to output the waves that has
been edited and stored after downloading the waveform data