Specifications

RIGOL DG10X2 Commands System
Programming Guide for DG10X2
2-46
BURSt
BURSt commands are used for setting the generator to output pulse sequence(called
burst) with specified cycles. Among CH1, burst could be generated based on sine,
square, ramp, burst or arbitrary waves.
DG10X2 supports following BURSt commands:DG10X2:
1. BURSt:MODE
2. BURSt:MODE?
3. BURSt:NCYCles
4. BURSt:NCYCles?
5. BURSt:INTernal:PERiod
6. BURSt:INTernal:PERiod?
7. BURSt:PHASe
8. BURSt:PHASe?
9. BURSt:STATe
10. BURSt:STATe?
11. BURSt:GATE:POLarity
12. BURSt:GATE:POLarity?
The detailed information of each command are:
1. BURSt:MODE
Command
Format
BURSt:MODE {TRIGgered|GATed}
Function
Select the burst mode.
Explanations
 In TRIG mode, the generator outputs a wave with specified
cycle number once receive an assigned trigger via sending
TRIGger:SOURce.
 In GAT mode, the output state of waves (“ON” or “OFF”)
depends on the external level used by [Ext Trig/FSK/Burst]
connector on the rear panel.
 The default burst mode is TRIG.
Example
BURS:MODE GAT
2. BURSt:MODE?
Command
BURSt:MODE?