Specifications

RIGOL DG10X2 Commands System
Programming Guide for DG10X2
2-22
OUTPut
OUTPut commands are used for setting the output parameters, such as: the output
switch, the output loads, the polarity of the waveform, the synchronous output signal
and the trigger output from CH1.
DG10X2 supports following OUTPut commands:
1. OUTPut
2. OUTPut?
3. OUTPut:LOAD
4. OUTPut:LOAD?
5. OUTPut:POLarity
6. OUTPut:POLarity?
7. OUTPut:SYNC
8. OUTPut:SYNC?
9. OUTPut:TRIGger:SLOPe
10. OUTPut:TRIGger:SLOPe?
11. OUTPut:TRIGger
12. OUTPut:TRIGger?
13. OUTPut:CH2
14. OUTPut:CH2?
15. OUTPut:LOAD:CH2
16. OUTPut:LOAD:CH2?
17. OUTPut:POLarity:CH2
18. OUTPut:POLarity:CH2?
The detailed information of each command are:
1. OUTPut
Command
Format
OUTPut {OFF|ON}
Function
Disable or enable the front-panel [Output] connector[Output]
connector. The default is “OFF”.
Example
OUTP ON
2. OUTPut?
Command
OUTPut?