Specifications

DG10X2 Commands System RIGOL

Programming Guide for DG10X2

2-3

APPLy

APPLy commands provide the most straightforward method to program the

generator over remote interface. Among following commands, the instrument could

set and output waveforms if OUTPUT function is enable.

DG10X2 supports following APPLy commands:

1. APPLy:SINusoid

2. APPLy:SQUare

3. APPLy:RAMP

4. APPLy:PULSe

5. APPLy:NOISe

6. APPLy:DC

7. APPLy:USER

8. APPLy?

9. APPLy:SINusoid:CH2

10. APPLy:SQUare:CH2

11. APPLy:RAMP:CH2

12. APPLy:PULSe:CH2

13. APPLy:NOISe:CH2

14. APPLy:DC:CH2

15. APPLy:USER:CH2

16. APPLy:CH2?

The detailed information of each command are:

1. APPLy:SINusoid

Command

Format

APPLy:SINusoid [<frequency>[,<amplitude>[,<offset>]]]

Function

Generate a sine wave with specific frequency, amplitude and DC

offset via CH1.

Explanations

 If the parameters you set are less than three, the sequence

would be: <frequency>, <amplitude>, <offset>.

 The default units of <frequency>, <amplitude>, <offset> are:

Hz, Vpp, V

Example

APPL:SIN 1000,5.0,-1.5