Datasheet

5
RIGOL
Key Frequency 2 mHz to 1 MHz
PWM
Carrier Waveform Pulse
Source Internal/External
Modulating Waveform Sine, Square, Ramp, Noise, Arb
Width Deviation 0% to 100% of the pulse width
Modulating Frequency 2 mHz to 1 MHz
External Modulation Input
Input Range 75 mVRMS to ±5 Vac + dc
Input Bandwidth 50 kHz
Input Impedance 1000Ω
Burst Characteristics
Carrier Waveform Sine, Square, Ramp, Pulse, Noise, Arb (except DC)
Carrier Frequency 2 mHz to 30 MHz 2 mHz to 60 MHz
Burst Count 1 to 1,000,000 or Innite
Start/Stop Phase 0° to 360°
Internal Period 1 μs to 500 s
Gated Source External Trigger
Trigger Source Internal, External or Manual
Trigger Delay 0 ns to 100 s
Sweep Characteristics
Carrier Waveform Sine, Square, Ramp, Arb (except DC)
Type Linear, Log or Step
Direction Up or Down
Start/Stop Frequency The same with the upper/lower limit of the corresponding carrier frequency
Sweep Time 1 ms to 500 s
Hold/Return Time 0 ms to 500 s
Trigger Source Internal, External or Manual
Marker Falling edge of the sync signal (programmable)
Frequency Counter
Function Frequency, Period, Positive/Negative Pulse Width, Duty Cycle
Frequency Resolution 7 digits/second (Gate Time = 1s)
Frequency Range 1 μHz to 200 MHz
Period Measurement Measurement Range 5ns to 16 days
Voltage Range and Sensitivity (non-modulating signal)
DC Coupling
DC Offset Rage ±1.5 Vdc
1μHz to 100 MHz 50 mVRMS to ±2.5 Vac + dc
100 MHz to 200 MHz 100 mVRMS to ±2.5 Vac + dc
AC Coupling
1 μHz to 100 MHz 50 mVRMS to ±2.5 Vpp
100 MHz to 200 MHz 100 mVRMS to ±2.5 Vpp
Pulse Width and Duty Cycle Measurement
Frequency and Amplitude
Ranges
1 μHz to 25 MHz 50 mVRMS to ±2.5 Vac + dc
DC Coupling
Pulse Width
Min Pulse Width ≥20 ns
Pulse Width Resolution 5 ns
Duty Cycle Measurement Range (display) 0% to 100%
Input Characteristics
Input Signal Range Brakedown Voltage ±7Vac+dc Input Impedance = 1 MΩ
Input Adjustment
Coupling Mode AC DC
High-frequency Rejection
On: Input Bandwidth = 250 kHz;
Off: Input Bandwidth = 200 MHz
Input Trigger
Trigger Level Range -2.5V to +2.5V
Trigger Sensitivity Range
0% (about 140 mV hysteresis voltage) to 100% (about 2 mV
hysteresis voltage)
Gate Time
GateTime1 1.310ms
GateTime2 10.48ms
GateTime3 166.7ms
GateTime4 1.342s
GateTime5 10.73s
GataTime6 >10s